Stern control arms and completed headers
Today we put the transmission back into the car and buttoned everything back up. If everything works out tomorrow the brakes and cat-back should go on!
Below you can see the high-flow cats mate up to the new headers. JHM offers a pre-lengthened set of O2 sensors since the O2 bungs have been relocated on the longtube headers.
Some "better" photos of the JHM/Stern motor mounts.
Here the Stern control arms have been installed.
The S4 goes under the knife…
Monday the S4 went under the knife to receive the first round of performance modifications. Take a look at the OEM exhaust manifolds. Proceed to cringe.
To gain access the exhaust manifolds we had to lower the motor. Pictured below, the transmission has already been removed.
The motor is supported so it can be lowered down enough to gain access to the exhaust manifolds.
Here you can see the JHM longtube headers installed.
This version of the headers uses v-band clamps.
JHM/Stern Motor Mounts
Thanks to JHM for hooking me up with a set of their modified Stern motor mounts. B6/B7 S4 motor mounts are 110mm shorter than the aftermarket mounts that are currently available; these mounts have been modified so they will fit.
